Site Content


Double Broadcast Epoxy Flooring:


Bedrock Double Broadcast Epoxy Flooring can be a solid color or a more decorative speckled colored quartz system. It is a 100% solids (solvent & water free), three component, color through, epoxy flooring system primarily used for finishing concrete or plywood floors. It provides a sealed, seamless, non-porous, easily maintained finished surface, approximately 125 mils thick.


Bedrock Double Broadcast Epoxy Flooring incorporates state of the art epoxy resins to chemically fuse aggregates into a multi-coat, high build flooring system. It consists of Cure & Seal Primer (optional for porous substrates), Bedrock Flexi-Coat waterproof membrane (if required), Bedrock Binder for broadcast coats, Rockote (topcoat) and CRU1 (optional topcoat fr added chemical resistance and color stability.)


Solid color (with pigmented epoxy) or multicolored quartz (with clear epoxy.)

Smooth, medium, or slip resistant finish textures available.


Follow instructions for preparation and mixing of component materials. Apply primer and allow to cure. Apply Bedrock Flexi-Coat, if waterproof membrane is required, Allow to cure. Apply Bedrock Binder neat.

While still wet, fully broadcast aggregate to excess. Allow to cure. Sweep and vacuum excess aggregate. Apply Bedrock Binder neat. While still wet, fully broadcast aggregate again and allow to cure. Sweep and vacuum excess aggregate and apply Bedrock Rockote LS as a clear high performance light stable epoxy topcoat. Allow to cure. Apply Bedrock CRU1, if required, and allow to cure.


Compressive Strength (ASTM D695)   10,500 psi min @ 7 days
Tensile Strength (ASTM D638)             1750 psi min
Tensile Elongation (ASTM D638)          3 percent
Tensile Shear                                           1800 psi min @28 days  77f   
Hardness Shore D (ASTM D2240)         85-90
Flexural Strength (ASTM C882)            4,500 psi
Bond Strength (ASTM C882)                 100% concrete failure
Indention (MIL-D-3134F)                       No indentation
Abrasive Resistance (ASTM D1044)      .19 grams maximum
Water Absorption (ASTM C413)            .1%

With CRU1 Top Coat:                                 Pencil Hardness 2H
Taber Abrasion, CS1  1,000 gms, 

1,000 cycles wt loss                                   50mgs


Resistant to mild acids, alkalies, detergents, solvents, skydrol, hydraulic fluids, lubricating oils, deicing salts, etc. CR2 and CRU1 have higher resistance to certain chemicals. See individual data sheets.